Module Replacement guide: How To Install and Replace Your LED Modules

Oct 10, 2023 in latest new 2 min read

The X Series LED module is a revolutionary LED module that can be replaced in under a minute.

Step 1: Identify the two lock points on the module.

Step 2: Insert a 3mm Hex key and twist counterclockwise.

Step3: Carefully remove the module from the screen and disconnect the: Power cable, Signal Cable, and safety hook.

Step 4: Complete the above steps in reverse to install the replacement module.

Installing LED modules involves securing the module with a safety hook and connecting the necessary flat ribbon and power cables.
After positioning the module on the sign and ensuring cables are clear of edges, lock points are identified and secured using a 3mm hex key or Allen wrench.
This process is repeated for each module, with a final check ensuring secure installation and proper alignment.
For a detailed guide on making or repairing flat ribbon cables, refer to the provided link.

Step 1: Ensure Safety

Before beginning the installation, attach the safety hook to the LED module to prevent it from falling during installation.

Step 2: Connect Flat Ribbon Cable

Connect the required flat ribbon cable to the LED module. If you need to make or repair a flat ribbon cable, refer to this link.

Step 3: Connect Power Cable

Attach the appropriate power cable to the LED module, ensuring secure connections.

Step 4: Position the Module

Install the LED module onto the sign, making sure to keep all cables clear of the edges to avoid damage.

Step 5: Identify Lock Points

Locate the lock points on each module, which are typically found in the center, approximately 2 inches from the top and 2 inches from the bottom.

Step 6: Secure the Module

Using a 3mm hex key or Allen wrench, insert it into each lock point and turn clockwise to secure, once at the top and once at the bottom.

Step 7: Repeat for Each Module

Repeat Steps 4-6 for each additional LED module you are installing.

Step 8: Final Check

Once all modules are securely installed, review all connections and placements to ensure security and proper alignment.

Additional Videos

Safety Notice

Always prioritize safety during installation. Secure all modules properly and ensure all electrical connections are safe to prevent any accidents or damage.

Troubleshooting

If you encounter any issues during installation or if the LED modules are not working as expected after installation, refer to your product’s manual or contact the manufacturer’s customer support for assistance.

Conclusion

Installing LED modules can be straightforward when following these steps. Secure connections, proper alignment, and adherence to safety guidelines are crucial for successful installation and operation.

Never miss a deal. Get Rewarded!